meshcore-cli
Contents:
- Installation
- meshcli over WIFI
- Usefull Commands
- Reference Sites
[Top][Home]
Installation
[Top][Home]
meshcli over WIFI
In order to enable the wifi service on the haltek V4, use the Bluetooth connection and the Android app.
- Go to --> Settings --> WIFI Settings and enter the SSID and password for the local network.
- The app will show the connection status and thw wifi IP address.
The wifi interface utilises port 5000 upnp. Use nmap to confirm this port is open on the haltek's allocated IP address.
The device is seen as "esp32s3-53CC54.home"
- Chipset (esp32s3),
- Unique ID (53CC54). The six hexadecimal characters represent the last three bytes of the device's unique Wi-Fi MAC address,
- Local Domain (.home).
Finally run the command in the terminal window.
[Top][Home]
Usefull Commands
[Top][Home]
Reference Sites
NoDak Mesh:
https://nodakmesh.org/meshcore/cli-guide
[Top][Home]
Glenn Lyons VK4PK
glenn@LyonsComputer.com.au
Ver:gnl20261110 - pre published v0.9